Can you please specify which linksys [Router] did you got? Is it the 'G' or the 'N' series? That would not make a difference in the configuration, but just to be in the picture. Which protocol did you pick up from there? PPOE or PPOA? Q-Tel is using these days the first one. After you configure the router, you must go to the 'Status' page to connect ... but i guess that you are using the new Linksys so this one comes with a software that runs a wizard which make it really easy. Did you specify those values 8/35 for the VC settings? Hope this helped, if you can just tell what is exactly the problem .. did you check the internet led on your router? is it up? If so ... Check your network settings, you might be using a static IP while the router is using DHCP to give you and IP.
Can you please specify which linksys [Router] did you got? Is it the 'G' or the 'N' series? That would not make a difference in the configuration, but just to be in the picture. Which protocol did you pick up from there? PPOE or PPOA? Q-Tel is using these days the first one. After you configure the router, you must go to the 'Status' page to connect ... but i guess that you are using the new Linksys so this one comes with a software that runs a wizard which make it really easy. Did you specify those values 8/35 for the VC settings? Hope this helped, if you can just tell what is exactly the problem .. did you check the internet led on your router? is it up? If so ... Check your network settings, you might be using a static IP while the router is using DHCP to give you and IP.